![]() ![]() 713XXXXX THROUGH 752XXXXX 801XXXXX THROUGH 852XXXXX 901XXXXX THROUGH 952XXXXX 001XXXXX THROUGH 052XXXXX 101XXXXX THROUGH 152XXXXX 201XXXXX THROUGH 252XXXXX 301XXXXX THROUGH 319XXXXX, INSTALLED IN CERTAIN RECREATIONAL VEHICLES AS ORIGINAL EQUIPMENT AND SOLD AS AFTERMARKET EQUIPMENT. #Weatherpro power awning motor serialĪ FATIGUE CRACK MAY DEVELOP IN THE BOILER TUBE WHICH MAY RELEASE A SUFFICIENT AMOUNT OF PRESSURIZED COOLANT SOLUTION INTO AN AREA WHERE AN IGNITION SOURCE (GAS FLAME) IS PRESENT.ĬERTAIN DOMETIC TWO-DOOR REFRIGERATORS MANUFACTURED BETWEEN APRIL 1997 AND MAY 2003: SERIAL NOS.In Episode 56 I explain the importance of understanding how your Power Awning can be retracted in an emergency. The emergency is usually when you want to leave in your RV and the Power Awning won’t come in. I break it down by the awning manufacturer. This applies Only to 12 volt RV Power Awnings.ĭometic/A&E 9100 and Weatherpro Awnings are the same when it comes to retracting them if the motor has failed. The process to override the motor and bring the awning in is the most effective if the awning is fully extended. There is a reason for this being necessary. The awning roller tube has three grooves in it and one of them is for a Pull Strap to be inserted to enable you to be able to control how the awning retracts. You should have the Pull Strap, if not you will need to purchase one from any RV Parts Store and you can use any Pull Strap for a Dometic/A&E Manual Awning. The 9100 or Weatherpro awning will need to be extended for you to insert the pull strap into the available groove on the Roller Tube. The rear of left end of the roller tube has a Torsion Assembly with a spring on it used for tensioning. You need to be aware of that so you understand how the awning operates. Before you do the next step you should have a person holding the awning pull strap to keep the awning from retracting out of control. After the strap is attached you will loosen the Hex Head Screw on the 12 volt motor that is located on the front of the awning, also called the right side. With the screw loose you can walk the awning towards the RV. To lock the awning in the closed position tighten the screw on the motor, the same screw you loosened to retract the awning.Ĭarefree of Colorado have their own unique spin on retracting an awning with 12 volt drive motor problems. It doesn’t appear that there is a simple solution to retracting a Carefree power awning with a bad motor. If there isn’t 12 volts going to the motor it is a little easier to work with. In this podcast I explain the process to manually override and a couple models of their awnings but not all of them.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |